Ryker IPS LED Fog Light Install

Buy this kit HERE

Install Video

LG-3050-2 RYKER IPS FOG LIGHT INSTALLATION INSTRUCTIONS

1. WITH AN APPROPRIATE JACK, LIFT THE FRONT OF THE RYKER TO TAKE THE
WEIGHT OFF THE RIGHT FRONT WHEEL.

2. REMOVE THE UPPER SHOCK BOLT. PLACE MOUNTING TAB ON SUPPLIED
LONGER BOLT, PLACE SPACER ON BOLT. INSTALL NEW BOLT SO THE NEW NUT
IS TOWARD THE FRONT OF THE RYKER.

3. ATTACH FOG LIGHT TO MOUNTING BRACKET WITH SUPPLIED M6 HARDWARE.
ROUTE THE PLUG UNDER THE BODY PANEL.

4. REPEAT 1 THRU 3 ON THE LEFT SIDE OF THE RYKER.

5. REMOVE LEFT AND RIGHT UPPER SIDE PANELS AND GLOVE BOX

6. REMOVE HOOD TO ACCESS BATTERY. DISCONNECT BATTERY.

7. ROUTE SUPPLIED WIRE HARNESS FROM BATTERY AREA TO UPPER LEFT BODY
PANEL AREA AND PLUG INTO THE AUX POWER LEAD.

8. DRILL 3/8" HOLE IN LEFT SIDE COVER AS SHOWN. INSTALL SWITCH INTO THIS HOLE.
SECURE THE WIRE HARNESS USING SUPPLIED ZIP TIES TO KEEP WIRES AWAY FROM THE ENGINE.

9. ATTACH THE RELAY BOX TO THE FLAT AREA ON THE RIGHT OF THE BATTERY
WITH THE SUPPLIED SHEETMETAL SCREW.

10. PLUG THE RIGHT FOG LIGHT INTO HARNESS AND SECURE TO THE FRAME
CROSS MEMBER WITH ZIP TIE. ROUTE THE HARNESS TO THE LEFT FOG LIGHT
AND ATTACH AND SECURE IT TO THE FRAME CROSS MEMBER.

11. ATTACH THE BLUE WIRE FROM THE RELAY TO THE POSITIVE SIDE OF THE
BATTERY.

12. CONNECT THE BLACK WIRE FROM THE RELAY TO THE NEGATIVE SIDE OF THE
BATTERY.

13. REINSTALL SIDE COVERS AND HOOD YOUR INSTALLATION IS COMPLETE.

14. POWER UP RYKER AND AIM LIGHTS AS DESIRED AND TIGHTEN ALL FASTENERS.

15. REINSTALL SIDE COVERS, GLOVE BOX AND HOOD. YOUR INSTALLATION IS COMPLETE.

16. WHEN YOU POWER UP YOUR RYKER ON THE SWITCH WILL CONTROL THE FOG LIGHTS.*

* ANY OTHER ACCESSORIES PLUGGED INTO THE AUX CIRCUIT DOWNSTREAM OF THE SWITCH WILL ALSO BE CONTROLLED BY THIS SWITCH. IF THIS IS NOT DESIRED , PLUG THE LAMONSTER FOG LIGHTS IN AFTER OTHER ACCESSORIES.

** NOTE THE FOG LIGHTS ARE NOT POWERED BY THE AUX CIRCUIT, THEY ARE POWERED BY THE BATTERY.